How to post material directly into Quality with Creation of Automatic Lot Size?

I'm Doing below Process @ goods Receipt.
 
Doing GR using  MIGO.
Doing Quality Record using T. code : QA32.
 
In this case, when I did a Creation Goods Receipt, system is not posting automatically in to Quality. So I checked the Quality setup in Material Master and Found that Post to Quality is not Showing. When in Inspection, Set up Active Flag is maintained for Inspection type, system is not showing Post to Quality stock Field and at the time of Goods Receipt, system is not posting directly to Quality. If I remove Active Field in Quality Inspection Setup, system is showing Post to Quality Flag and Posting directly into Quality at the time of MIGO. But it is not allowing to do Lot Creation Manually. 
----------

First of all, you Cancel the present posting you are doing and then do follwing things:

1. Go to material amster MM02 of that material and select to QM views - then click on tab Inspection set up and select inspection lot origin like 01(Goods reciept) and check on active colum which is Must for RM, and PM, then you will see  post to inspection stock will automatically check this means that when you will now do the GR then material will automatically go to Quality.
After putting lot origin like 01, 08 etc, save the material. (Refer sceen A).
 
2. Do your MIGO as normal but before saving the MIGO once check that in WHERE tab the Stock type material should by Default automatically Shown Quality Inspection (Refer Screen B).
 
Screen A : MM03 
When use, put Inspection type 01 say and click on active then automatically post to inspection stock, no need to checked or unchecked it.

Screen B : MB51

Have a SAP QM Problems?
SAP QM Forum - Do you have a SAP QM Question?

SAP QM Books
SAP Quality Management Certification, Interview Questions and Configuration Reference Books

SAP QM Tips
SAP QM Tips and Quality Management Discussion Forum

Best regards,
SAP Basis, ABAP Programming and Other IMG Stuff
http://www.sap-img.com